addc182
01-07-2007, 04:46 AM
Homemade Stun Gun
A homemade stun gun is quite an easy hardware hack, all that is required is;
# 1)A disposible camera (Perferibly a Kodak one)
# 2)Soldering Iron
# Step 1)First off, take off the protective plastic case of the camera.
# Step 2)Remove the battery so you don't shock yourself.
# Step 3)You'll see a little light bulb about 3/4 inch long. Carefully remove that with out destroying anything.
# Step4) You should see two pieces of copper on both sides of the bulb.(see picture, Red Circles) Solder one wire on to each one of these, not together.
# Step5)Slap the battery back in and hold down the button, touch the wires to desired object and watch the sparks fly!
# Safety Issues
# Because this isn't very safe and you have a chance of getting shocked, (personal experience) an easy way to make a protective case is to.
# Step1) Cut apart the hard plastic inside of a "Five Star" binder. The tough plastic is very flexible and and can just be glued together.
# Step2)Cut to fit the stungun inside.
# Step3)Glue together. Don't forget to cut a hole for the button, cardboard works as a good depressor so you don't have to make direct contact with the button. Also slapping a cut up rubber glove over the stungun adds extra protection.
Enjoy!
The pictures for the tutorial can be found here http://www.i-hacked.com/content/view/181/48/
A homemade stun gun is quite an easy hardware hack, all that is required is;
# 1)A disposible camera (Perferibly a Kodak one)
# 2)Soldering Iron
# Step 1)First off, take off the protective plastic case of the camera.
# Step 2)Remove the battery so you don't shock yourself.
# Step 3)You'll see a little light bulb about 3/4 inch long. Carefully remove that with out destroying anything.
# Step4) You should see two pieces of copper on both sides of the bulb.(see picture, Red Circles) Solder one wire on to each one of these, not together.
# Step5)Slap the battery back in and hold down the button, touch the wires to desired object and watch the sparks fly!
# Safety Issues
# Because this isn't very safe and you have a chance of getting shocked, (personal experience) an easy way to make a protective case is to.
# Step1) Cut apart the hard plastic inside of a "Five Star" binder. The tough plastic is very flexible and and can just be glued together.
# Step2)Cut to fit the stungun inside.
# Step3)Glue together. Don't forget to cut a hole for the button, cardboard works as a good depressor so you don't have to make direct contact with the button. Also slapping a cut up rubber glove over the stungun adds extra protection.
Enjoy!
The pictures for the tutorial can be found here http://www.i-hacked.com/content/view/181/48/